Skip to content

Dyeing Lab

How the dyeing lab works: lab dips, shade matching, recipe calculation, colour measurement and the step that matters most, getting a lab result to repeat in bulk.

5 guides

About Dyeing Lab

Every bulk shade starts in the lab. A lab dip is a small dyeing made to match the buyer's standard, and it is judged in a light cabinet and on a spectrophotometer before the recipe goes to the floor. A good lab dip is not enough on its own: it has to be made with the same fabric, the same chemicals and a process close to the bulk process, or the shade moves when it reaches the machine.

This section explains how we read a colour difference, what Delta E and CMC tolerances mean in practice, how to correct a recipe step by step, and why lab-to-bulk correction is part of normal work rather than a failure. It will also cover recipe calculations: dye percentages, liquor ratio, and salt and alkali amounts for each depth of shade.

Questions about dyeing lab

What is a lab dip?

A lab dip is a small sample dyed in the lab to match a buyer's colour standard. It is checked visually in a light cabinet and measured on a spectrophotometer, and once approved its recipe becomes the starting point for bulk dyeing.

What does Delta E mean in shade matching?

Delta E is a single number for the colour difference between a sample and the standard, measured on a spectrophotometer. The smaller it is, the closer the match. Most buyers set a tolerance, often with the CMC formula, rather than asking for zero.

Why does a lab dip shade change in bulk?

Bulk differs from the lab in liquor ratio, heating rate, machine action and water. Differences in the fabric itself, such as yarn lot or pretreatment, also move the shade. That is why bulk recipes usually need a small correction from the lab recipe.